The GutterBrush Blog

Probably not. But there is no mistake about what’s in this gold plated vending machine.  Abu Dhabi’s Emirates Palace Hotel became the first place outside Germany to install “gold to go, the world’s first gold vending machine”. Those in the Gulf region who can clearly afford it can now grab “gold to go”, much like a latte or donuts, from a hotel lobby in the United Arab Emirates. Now when the gold fix strikes all you need to do is find one of these machines and presto, gold! Only one day after its inauguration, the shiny machine attracted many spectators of many different nationalities who had gathered to watch whenever an enthusiast was struck with the urge to splurge on a bar of the precious metal. The gold rates are constantly updated inside the shiny machine — itself gold-plated — in the hotel’s lobby, courtesy of a built-in computer connected to a dealer which sells gold online.

How far we have come from the days of the California gold rush!

Do you need a new roof? Are you trying to decide how to save some money on the job? One way people try to do this is to place the new roof installed over an existing layer of roofing. This technique is quite common in many areas and many roofing contractors don’t see any problem with this method and have no problem trying to sell homeowners on a lay-over or go-over as this technique is called.

Don’t do this. EVER.

Here are the top five reasons laying a new roof over an old one is a terrible idea.

First, there are sure to be areas that have or had leaks and they can’t always be addressed properly

There is a good chance that your old roof had some problem areas including possible leak spots, whether you noticed them or not. Without tearing off the old roof and properly identifying these types of trouble spots and determining where the leak was coming from and traveling to it is impossible to tell what areas of your roof may need some special attention.

Second, any rotted wood under the existing roofing will only get worse leading to an even more expensive fix down the road.

There could be areas that have rotted wood hiding under the old roofing. These rotted areas need to be identified and replaced before a new roof is installed. Obviously if your roofing contractor is only doing a lay-over roofing installation then these rotted areas will remain covered up and only get worse as the years go on. Also the nails holding down the shingles in areas with rotted wood cannot properly do their job and you have a much higher risk of shingles blowing off in those areas.

Third, the eaves, rakes and valleys always need special treatment and not doing so will cause more costly repairs later.

This is a big one. The eaves, rakes and valleys of your house need special attention when your home’s roof is being installed. This is especially important in colder climates like Massachusetts, where we are located. In the winter time the eaves of your house are under attack by Mother Nature, whether it is through ice dams, snow build up, or just the constant freezing and thawing that occurs throughout the winter season. When a new roof is properly installed the roofing contractor needs to put new aluminum drip-edge around the entire perimeter of your roof.

Next they need to apply a 3 foot wide section of ice & water barrier around the perimeter as well as in any valleys on your roof. Then they can begin to install the new roofing. Without tearing off the original roofing there is no way to properly install the new drip-edge or ice & water barrier. On a lay-over type of roofing install, the roofing contractor is counting on the existing products on the home’s roof to still be up to par and be able to handle the winter conditions. All too often the old products fall short whether it was because they have outlived their lifetime, were sub-par to begin with, or maybe they were never there to begin with (all to often the latter is the case with ice & water barrier).

Fourth,  the extra roofing weight is no good for old rafters and can cause structural failure and safety hazards in the structure.

One of the more obvious problems with a lay-over re-roof is the added weight of the extra layer of shingles. On most newer homes this is not an issue, however many older homes have rafters that are considered undersized by today’s framing standards. It is not uncommon to see 2×6 rafter systems on many of these houses. Now in most situations a 2×6 rafter is undersized to begin with and you certainly don’t want to be adding the weight of a new roofing layer on top of an old roofing layer to these already undersized rafter systems.

Fifth, adding a roof on top of another roof will lead to a shorter roof life expectancy.

Most responsible roofing contractors agree that a lay-over roof will decrease the new roof’s lifetime by about 25%. This fact alone means that any money you might have saved by doing a lay-over, as opposed to a tear-off and new roof install, was only a short term savings. In addition, you now have 2 layers of roofing that will need to be removed the next time your roof is done and that will also add more cost to the job

Tearing off the old roof and then installing a new one is always superior to laying a new on on top of an old one. And as always, do not forget your gutter protection system needs!

GutterBrush can prevent this from happening.

Excessive amounts of water overflowing from your gutter system could cause a number of serious problems around your home, some of which could cause you hundreds if not thousands of dollars to repair. But there are just some things that no gutter protection system, even GutterBrush, can solve. One of those situations is a heavy deluge of rain that courses down a roof’s slope and into the gutter with such force that it can not be properly channeled into the gutter and out the downspout. However, leaking or overflowing gutters should never be ignored and a properly installed and clean gutter system should function to move water safely down the gutter and out the downspout in every other type of rain. If they leak or overflow during normal conditions perhaps we can help you to maximize the effectiveness of your gutters and gutter protection system during normal rainfall conditions.

First, if your house is fairly long where the gutters are continuous along the entire length and the only downspouts are on both ends this could cause some over flowing and leaking to occur. Most homeowners prefer this gutter/downspout configuration for aesthetic reasons because a downspout does not have to be installed right in the middle of the house which is usually right near the entrance to the house. However, often times only having a downspout at the end of the gutter system leads to the inability for the gutter system to handle the volume of rain that is falling. An effective solution to this problem is to have the one end raised just as high as you can so that the flow will be sufficient for the water to exit the preferred main exit end before ever running over. You can also investigate the installation of a large gutter on your home’s exterior to accommodate larger volumes of water flow.

Second, make sure your gutters are not leaking as this can lead to the misidentification of the problem you face. To quickly and effectively repair a leaky gutter, first remove debris and wash out the gutters with water. Second, apply a silicone gutter seam sealant to gutter seams, exposed nail/screw heads, and minor holes as needed. Third, you should absolutely replace any section of gutter that is pitted or rusted through. Fourth, make sure that all gutter sections are secured properly to the fascia boards and replace any rotted fascia boards as needed. Fifth, install drip flashing around all roof edges. Finally, fill the gutters with water using a garden hose to check for leaks and proper drainage. Next time it rains watch the gutters for leaks and overflows. If water still overflows the gutters, then you may need to adjust the slope towards the downspouts and or add additional downspouts as previously mentioned. In addition, you might consider installing larger downspouts that will help prevent gutter overflow but these should be coupled with the installation of downspout extensions to divert water away from the house structure in order to avoid costly water damage to your property.

All of this rain gives you an opportunity to give your garden a nice hearty drink without chipping away at your efforts to conserve water and save money. Maybe it is time you consider a rain barrel and begin collecting the runoff from your gutters that would otherwise go to waste and even hurt your landscaping and cause leaking around foundations?

Although any old 55-gallon drum or keg will do, there’s no reason to litter your yard with these unsightly relics. Instead, give your local water department a call because many towns and municipalities now offer water barrels free of charge to local residents in an effort to increase sustainability and decrease public water supply usage. Those that don’t often hold workshops on other ways to conserve water, or offer incentives to citizens willing to secure barrels on their own.

If you are into DIY projects you can even make your own rain collection system  for very short money. Just be sure you correctly position them underneath your gutters’ downspouts to maximize the collection of runoff during the next rainfall. But remember, even if you filter it first, the water you collect is better suited for drenching thirsty garden than satisfying a thirsty throat.

If you’d rather just buy a rain barrel, there are some really neat ones available online at www.aquabarrel.com

Good luck!

Collecting water from the sky to be used on the ground.

We hope you find this spring cleaning checklist helpful.

Save for a few enthusiasts of home repair projects, one of the most dreaded for homeowners is roof repair. A roof that leaks can cause major damage to the structure of your home and, if left unchecked, could eventually lead to the damage of many of the possessions inside. Asphalt shingles, which are what you’ll find on most roofs, generally only last 15 to 20 years and can require a lot of maintenance and upkeep.

If you’re looking for an alternative to the exhausting process of roof repair and maintenance with asphalt shingles, you may want to consider rubber roofing. Worried that rubber roofing sounds like stretching out a dozen Goodyear treads over your home? Don’t worry–although rubber roofing materials can come in a roll for buildings with flat roofs, you can also buy rubber shingles, which look much like slate shingles and come in a variety of colors and designs.

Another advantage to using rubber roofing materials is that most rolls and shingles are composed of recycled tires, saw dust and slate dust, which are much more eco-friendly than other roofing materials. Although rubber-roofing shingles can be more expensive than asphalt shingles, rubber roofs are much more durable and less likely to crack and crumble through tumultuous weather and drastic changes in temperature. Rubber shingles are also much cheaper and lighter than slate shingles–if that’s the style you’re looking for–and are similarly fire resistant. Rubber roofing materials also last much longer and require less maintenance–most manufacturers warranty their roofs for thirty to fifty years, and some even carry a lifetime warranty. The first rubber roof, installed on a home in Wisconsin in 1980, is still holding strong today!

Airport body scanning raises radiation exposure while using gutterbrush simple gutter guards does not. Because safety is always a priority in our pursuits and because we travel a bit we wanted to share the risks associated with airport body screening.

An inter-agency report (Inter-Agency Committee on Radiation Safety report, which is restricted to the agencies concerned and not meant for public circulation) stated that  governments must explain any decision to expose the public to higher levels of cancer-causing radiation while also suggesting that pregnant women and children should not be subject to scanning, even though the radiation dose from body scanners is “extremely small”. The group putting this report forward includes the European Commission, International Atomic Energy Agency, Nuclear Energy Agency and the World Health Organization.

Please keep in mind that an accurate assessment about the health risks of the screening won’t be possible until governments decide whether all passengers will be systematically scanned or randomly selected, the report said. Governments must justify the additional risk posed to passengers, and should consider “other techniques to achieve the same end without the use of ionizing radiation.” However, President Obama has suggested using upwards of $734 million to implement airport scanners that use x-rays and other technology to detect explosives, guns and other contraband.

“There is little doubt that the doses from the backscatter x-ray systems being proposed for airport security purposes are very low,” Health Protection Agency doctor Michael Clark said by phone from Didcot, England. “The issue raised by the report is that even though doses from the systems are very low, they feel there is still a need for countries to justify exposures.” So what is the risk?

Most of the scanners deliver less radiation than a passenger is likely to receive from cosmic rays while airborne, the report said. Scanned passengers may absorb from 0.1 to 5 microsieverts of radiation compared with 5 microsieverts on a flight from Dublin to Paris and 30 microsieverts between Frankfurt and Bangkok, the report said. A sievert is a unit of measure for radiation.

The U.S. Transportation Security Administration has said that it ordered 150 scanners from OSI Systems Inc.’s Rapiscan unit and will buy an additional 300 imaging devices this year. The agency currently uses 40 machines, which cost $130,000 to $170,000 each, produced by L-3 Communications Holdings, Inc. at 19 airports including San Francisco, Atlanta and Washington D.C. Oddly enough the U.S. TSA has not ordered a single linear foot of gutter protection such as gutterbrush to protect their gutters at airports across the United States.

This will never happen with gutterbrush simple gutter guards